Kenmore Series 200 Washer Triple Action Agitator Manual (2024)

FAQs

How to reset Kenmore series 200 washing machine? ›

RESET - Rotate cycle selector knob counterclockwise to clear sequence. a. Rotate cycle selector knob counter-clockwise one full rotation and the control panel should beep.

The most common reasons your Kenmore washer is not agitating are a malfunctioning electronic control board, faulty actuator or a jammed door lock assembly.

Some common causes include incorrect wash cycle or spin setting, an imbalanced load, a faulty lid switch assembly, a worn drive belt, a defective door latch, a malfunctioning motor control board, or damaged stator or rotor.

If your washer is plugged into an outlet, simply unplug the unit for one minute and then plug the unit back in. If the washer is hard-wired to the power supply, turn the breaker off at the home electrical panel that powers the washer for one minute and then turn the breaker back on.

Appliances do not have a reset button on them - to reset any appliance you UNPLUG the unit from the outlet for 3 minutes - plug back in - or turn off breaker to outlet and appliance for that long - then turn back on. That will reset the control computer board and reset the appliance.

If your washer won't agitate but spins, a broken agitator may be to blame. The agitator is the centerpiece in a top load washer that agitates and moves the clothes through the water during the wash cycle. The output shaft of the transmission is splined to the agitator to secure it in place.

There are various reasons the agitator may not be working: Something is jammed at the base of the agitator. The lid switch is broken. Your washer's agitator is broken.

If your agitator is worn or damaged on any part of it, particularly on the splines, or if you experience little to no resistance when turning it manually, you will need a replacement agitator.

A slow spin speed may have been selected. A slow spin speed will eliminate less water than a fast spin speed. Cold water can make clothes feel more wet. If the ground water temperature is very low where you live or during a certain season of the year, this could make the clothes seem to be more wet.

Your laundry loads may be too heavy or unbalanced if your washer is spinning slowly or stuttering. Heavy loads can also cause your washer to "walk" or move forward when it runs. Try washing smaller loads, distributing your laundry evenly when you fill the machine and ensuring the washer is level on its pedestal.

Why are my clothes not fully wet in the washing machine? ›

Check the water level setting first to adjust if possible . Check with the manufacturer how to correct or a defect or recall in the washer . If you have to add water there must be an issue with the flow level that is cut off too soon . That prevents the tub from fill with enough water.

The agitator could come off the base if not seated properly. It can easily be snapped back in place: Line up the grooves in the agitator auger with the agitator base. Turn counter-clockwise until it locks into place.

Twist off the bolt and carefully lift the agitator. You can soak it in bleach or use a baking soda-vinegar scrub. While you have the agitator removed, you can also check to see if any dirt has collected under the agitator. You can also use any household cleaner or the baking soda-vinegar scrub to clean this area.